Sailormilan2 Posted May 21, 2015 Report Share Posted May 21, 2015 Does any one have a die to chase the buttress threads on a Mauser bolt shroud? I just got a commercial one that either wasn't finished, or was cut out of spec. Quote Link to comment Share on other sites More sharing options...
donmarkey Posted May 22, 2015 Report Share Posted May 22, 2015 No but how much of a hurry are you in. I need to repair some electronics on my machine to thread but should be up in a few months. I have a few to cut also so I could add yours to the run easily enough. Don Quote Link to comment Share on other sites More sharing options...
Sailormilan2 Posted May 25, 2015 Author Report Share Posted May 25, 2015 No rush, Don. I'll periodically check with you to see if it is read. Quote Link to comment Share on other sites More sharing options...
Clemson Posted May 27, 2015 Report Share Posted May 27, 2015 I run into the problem periodically, and if it isn't too bad, I lap the threads into the bolt body using 600 grit lapping compound. Bill Jacobs Quote Link to comment Share on other sites More sharing options...
ken98k Posted May 27, 2015 Report Share Posted May 27, 2015 I run into the problem periodically, and if it isn't too bad, I lap the threads into the bolt body using 600 grit lapping compound. Bill Jacobs I've had to do that also. Quote Link to comment Share on other sites More sharing options...
Sailormilan2 Posted May 28, 2015 Author Report Share Posted May 28, 2015 The problem with mine, is that it won't even start in either of the two bolts that I tried it with. Quote Link to comment Share on other sites More sharing options...
Dr.Hess Posted May 28, 2015 Report Share Posted May 28, 2015 Maybe some time with a small file? Put it up against a known good part and compare to see what's off. It might just have a bugger on the thread that you can clean up. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.