Thanks Guy's
I'm on the North side of the 49th parallel and only have one receiver to do. I doubt hat Blanchard's would be an option for me, so guess I'll just limit mods to my receiver. I've done some research, but this was a new issue for me!
Don
So who would normally do gas carburization. Is it a gunsmithing process or something with industrial applications. I'm not sure where I'd look in Yellow Pages!
I'm just starting my first mauser build and it's not something I had heard mentioned before!
Thanks
Don
I've been following this thread and am a bit confused! When you say heat treating, I interpret that to mean heating the whole receiver to a high temperature and quenching. Grain structure would change throughout the metal and warping would be a real possibility? Or do you mean some sort of case or surface hardening? If so whats the process and who would I get to do it?
THANKS
Don
RDFRENCH31
I've been looking at add's for that book is well. I think it has a section on setting up and aligning a lathe for rebarreling. I would be interested in your review of that information???
I had posted a question on that subject under Tips of the Trade on this forum but haven't received any replies.
THANKS
Don