Jump to content
Military Firearm Restoration Corner

lathedog

Members
  • Posts

    1
  • Joined

  • Last visited

lathedog's Achievements

0

Reputation

  1. If the receiver is trued on a mandrel, and the barrel shank was cut between centers, you should not get more than .0005 to .001 crush. Planning on having .002 or .003 is probably fair if you are using "as found" parts but it could get you into .002 to .003 of trouble. It could also tell you that you have a thread fit interference somewhere. Also, did you measure receiver face to highest point on the bolt with the extractor installed? If you are measuring to highest point on the lug you are probably ok on a Swede but I would not shortcut that step. I'm just sharing mistakes I have made in the past.
×
×
  • Create New...