Posted 06 August 2009 - 02:56 PM
Posted 06 August 2009 - 09:16 PM
I haven't used this one. I've used JB Weld and other epoxies.
Just about anything that is going to set up with a density harder than walnut would likely work. IMHO
Just a side note "PC-7" seems to be a brand. There are several 'types' made by PC-7.
The one in your link should be OK. I've used the wood filler version and been damn disappointed.
I had a pin hole in the porcelain on steel tub of my dish washer. I ground away all the rust to clean
metal and used a dab of PC-7 white marine epoxy. The dish washer did fine for another 7 years till
the motor gave out.
Don't forget to wax up your steel as a release agent and go for it.
Posted 07 August 2009 - 02:55 PM
I used it simply because I had some and it was a "low priority" bedding project. I have quite a bit of it having used it for other applications. It is definitely harder than walnut.
I used Minwax paste wax and it popped right out. I worked in two stages: did the front ring and then the barrel forward of the front ring. I didn't get real aggressive.
Posted 08 August 2009 - 08:57 PM
Paste wax as a relese agent? Never gave that any thought. Stupid question but is this stuff a car wax or what?
Posted 08 August 2009 - 09:16 PM
Bob used Minwax, some guys swear by Johnson wax. I use something called insulating wax, it actually mentions use
as a release agent.
Posted 08 August 2009 - 10:10 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users