Brenden Posted October 24, 2009 Report Share Posted October 24, 2009 Got a quick question for you all. For the wheeler drill and tap fixture, is it top plate number one for mausers and number 2 is for enfields and other items? Thanks. Brenden Link to comment Share on other sites More sharing options...
tinkerfive Posted October 25, 2009 Report Share Posted October 25, 2009 Here is a hint Set the base on the receiver where they should go and mark through the holes with a sharpie. It makes aligning the jig a bit easier and figuring out which number to use. It's been a little while since I've drilled one. As I remember the jig is really only set up for std. length receivers. To do an intermediate you need to reset between drilling the front and rears. Tinker Link to comment Share on other sites More sharing options...
Brenden Posted October 26, 2009 Author Report Share Posted October 26, 2009 Thanks Gentlemen. Anybody know where I can get some directions at? Mine didn't come with any. Thanks. Brenden Link to comment Share on other sites More sharing options...
odies dad Posted October 26, 2009 Report Share Posted October 26, 2009 PM me your address and I will send you a copy of mine. Link to comment Share on other sites More sharing options...
Recommended Posts