Jump to content
Military Firearm Restoration Corner

dukhntr

Members
  • Posts

    3
  • Joined

  • Last visited

Contact Methods

  • Website URL
    http://
  • ICQ
    0

Profile Information

  • Location
    Minnetonka, Minnesota

dukhntr's Achievements

0

Reputation

  1. Monte: PM sent back. Thanks again for the help. Tinkerfive: Thanks for the post! I can now see the wisdom of your post. I got it done last night. The bolt closes more (but not all the way) on the NO GO gage than I wanted it to, but it still (thankfully) will not close on the NO GO gage. Tonight, I remove the barrel and debur the chamber mouth and put abevel in that area. I will also polish the chamber, as set forth above. (Thanks Roscodoh and Monte 6ab for these ideas). Thanks to all for the help. Dukhntr
  2. OD: Thanks for the reply. That was what I was looking for.... the fact that I needed to completely strip the bolt before starting the reaming process, and then use a stripped bolt to chek the headspace. Z: Yes, I will ream through the receiver. Als, no lathe at this time. Thanks Again. Dukhntr
  3. About to hand ream my first A&B Barrel. I believe that there was something written in one of the old posts about stripping the bolt, when reaming the chamber, and checking with the GO Gage. Is this correct? Any other things to watch out for? Thanks for any help. Dukhntr
×
×
  • Create New...