Jump to content
Military Firearm Restoration Corner

How To - Remove M98 Military Trigger For Replace


ut1031

Recommended Posts

I just received my new Boyds trigger and it looks fairly easy, but just wanted to make sure i am doing this right. I have dremeled my stock to allow the trigger to fit, but need instructions as to removing the original military trigger.

Thanks,

Kelly

Link to comment
Share on other sites

Pretty simple, squeeze the sear against the receiver and tap out the pin. There is a spring that may launch if you don't grab it. Save the pin to reinstall the new trigger.

You will likely need to remove some metal from around the trigger opening in the guard as well as in the stock.

Link to comment
Share on other sites

Guest Guest

Be aware that some of these pins are tapered so you can pound on one side all you want to no avail sometimes. If such is the case, turn the action over and pound on the other side. Be sure to use the proper sized rod to tap this pin out.

Link to comment
Share on other sites

×
×
  • Create New...