Jump to content
Military Firearm Restoration Corner

Barrel Removal


cowboybart

Recommended Posts

The 700 wrench fit the receiver and I didn't modify the wrench. I placed the recoil spud against the relief for the Rem recoil lug. It came loose w/o too much effort. If it was rusted and frozen on there I would have needed to mill out the wrench and give the recoil spud more support.

Link to comment
Share on other sites

I didn't need to notch my wrench to remove the barrel. I don't plan on putting it on that tight so I won't notch it to install the barrel either.

 

Does anyone have the John Deere shim part numbers, that riceone was talking about (in the above link)?? I'd like to have some on hand.

Link to comment
Share on other sites

×
×
  • Create New...