horse trader

we stopped working on weedeaters because they are so cheap unless there a stihl or echo its not cost effective to work on.the no.1 reason most 2 cycle motors dont run is the exhaust ports are carboned up take the muffler off and check to see there open.we buy most of are parts from stens.

both coming and going were on sat.the sat.going there was a little snow on ground perfect hunting.i wonder if the farm kids are to busy watching tv,computers and games to go hunting anymore.

just got back from a trip on 70 across ohio,ind.and ill.good weather for hunting and not one time did i see hunters in the fields,coming or going.scarey

maple,cherry,myrtle,

just came out on yahoo one third people in d.c. illiterate.i wonder how many or politicians?

ive never did internal threads on receiver before but i was thinking,i wonder instead of large ring going with a rem.700 barrel thread not quite as big not much difference at c ring coming out im sure it could be done but if there not out century and sog have turks missing bolts that would be alot cheaper.

sometimes when you take barrel off you can tweak the receiver a little so as the original bolt will act like yours a little stoning will usually free up.

ive heard that you can smell them and hear them snore for 100 yards away.next problem to think about is what would a chair look like if your knees bent the other way.

fritz your right about the sue you society,these kids in gunsmithing school if they dont make it as gunsmiths they can become lawyers with all the law classes and insurance courses,no tung oil causes allergies,no trigger pulls under 3r4 lbs etc.

not to steal the thread but brownells next month flyer shows how to cut the root 2/3 then heat and bend down then fill gap in and finish.a interesting point,ive been doing them this way for 40 years,i learned from a gunsmith that went to school with the pillars of the gunsmithing world or new them on first name basis.point is back then there were no migs, tigs,or fancy welders he stuck a bolt in the end a wet towel around the face and arced it up with a old lincoln or used ox/act with a coat hanger.now when people talk about welding bolts the young kids would have a heart attack at this method.

clemson the reason your mount if it was a b square 1 piece was off is because they're was a batch miss drilled i had a dozen i had to send back.also i have a wheeler jig and i had to notch the front pillar for the k kale to square up.finally on the wheeler jig if your doing arisaka the jig i got,the hole pattern doesnt match up to any mount.thanks keep up the good work on these help sessions.