Jump to content
Military Firearm Restoration Corner

donmarkey

Members
  • Posts

    1,482
  • Joined

  • Last visited

2 Followers

About donmarkey

  • Birthday 06/16/1974

Contact Methods

  • Website URL
    http://
  • ICQ
    0

Profile Information

  • Gender
    Male
  • Location
    Detroit MI

Recent Profile Visitors

43,245 profile views

donmarkey's Achievements

0

Reputation

  1. Northern brewer has a big selection of them. Too late this year for me. Maybe next year
  2. Even the small newer ones are 50amp. Ours is under 30’ and 50a. Anything prepped for 2 acs
  3. Which rhizomes are you trying? There was a beer garden here that had them going and they used to let you pick. I never knew what the were but would use them in a summer wheat
  4. https://4drentals.com/product/large-ring-barrel-die-98-mauser/
  5. I wouldn’t hesitate to use it as to heat treating. The problem with scrubbed actions in they are true on the outside anymore. I would surface grind or mill the area that the scope bases mount to insure they are parallel and measure to see if shims or custom mounts are in order.
  6. Brownells used to maybe still does sell a center punch made just for that. Super glue the base on then punch and drill. You can regrind a pin punch also. I just use the mill and no jig. Dial in center of the y axis then dry fit the base on where you want and drill with a center drill, then the #31. Then move the x axis the spacing of the screws then drill again.
  7. https://www.apexgunparts.com/98-mauser-barrel-.270-22inch-wilson-arms-gd.html good price on 270 barrels
  8. I would think the market is so low on them no one will stock them again. Special order only. Shilen, Douglas, McGowan etc. If looking for a budget build I’d look to the used market.
  9. Go for it. Just don’t drill all the way thru the front most hole!
  10. Meyer arms. Nathanial Meyer is great to deal with.
  11. The old Gibbs detectable mags were single stack.
  12. Brownells sells a fixture to hold the receiver mandrel to allow grinding. I use something a little more technical and in the surface grinder. But take a look and get some ideas. A cup wheel in the drill press is a makeshift surface grinder.
×
×
  • Create New...